Canon GX7000 support code 147C

Can you keep using it?

Contact customer support if any of these apply

!147C comes back immediately after reseating the supplies.
!The printer cannot finish startup because the same recognition problem returns every time.

If the printer still starts normally: Finish the first checks once, then stop if the same message repeats or the printer still cannot return to ready.

What to check first

Step-by-step checks

1
Safe first step
Open the supply area and confirm each installed component is seated correctly.
Start with the official recovery step before moving on to parts or deeper servicing.
2
Safe first step
Reseat the affected part carefully and close all covers firmly.
3
Safe first step
Restart the printer once after the supply check.

Background

What this message usually means

Canon uses support code 147C when the GX7000 family sees a consumables installation or recognition problem that keeps the printer from proceeding normally. It usually means the installed supply needs to be checked, reseated, or confirmed against the printer's expected setup.

Diagnosis

Likely causes

Most common

A supply is not fully seated or recognized correctly.

Common

The printer was restarted before the supply change completed cleanly.

Possible

A related cartridge or tank component is mismatched or still partially latched.

Service

When service or replacement is more likely

-Repeated installation-state faults after a clean reseat can point to a defective consumable or recognition issue inside the printer.

Related codes in this family

1405

The printhead or cartridge installation state does not look correct.

Explore more

More Canon printer families

GX1000 series

GX1020, GX2020, GX3020, and more.

GX4000 series

MAXIFY GX4020, MAXIFY GX4050, MAXIFY GX5020, and more.

MB2700 series

MB2710, MB2720, MB2740, and more.

Keep browsing

Where to go next

Back to GX7000 series

Browse the rest of this printer range and compare nearby messages.

More Canon families

Move sideways into related printer ranges from the same brand.

Browse all printer guides

Search across brands, families, and common printer error messages.

Source notes

Canon's GX7000-series support-code list includes 147C in the consumables installation and recognition error family.

Built around Canon GX7000-series support-code guidance. Exact wording, tray names, and supply labels can vary slightly by region and model variant.

Printer error codes can vary a little by firmware, region, and exact model variant. Use this guide as a family-level starting point and stop if the next step would require disassembly or service-mode changes.

Known family variants: GX7010, GX7020, GX7040, GX7050, GX7060, GX7090

Last reviewed: 2026-04-12

Reference: Open reference

147C - A consumables installation or recognition problem was detected.