Can you keep using it?
Can you keep using it?
Contact customer support if any of these apply
- !W-01 returns on clean paper after several careful clears.
- !You cannot reach the jammed piece without forcing panels or rollers.
What to check first
Step-by-step checks
- 1
Safe first step
Clear the jam fully before restarting the job.
Start with the official recovery step before moving on to parts or deeper servicing.
- 2
Consumable check
Remove any visible scraps and check the paper path carefully.
- 3
Consumable check
Reload flatter paper if the same stack keeps jamming.
Background
What this message usually means
Epson uses W-01 for a paper-jam warning on the ET-2980 series. The official guidance is to remove the jammed paper, press the button shown on the LCD to clear the error, and if needed restart the product.
Before the message
What users usually notice first
Messages like this often appear after the printer fails one of its normal startup, supply, or paper-path checks and cannot return to ready state cleanly.
Diagnosis
Likely causes
Paper is jammed in the feed or output path.
A torn scrap is still blocking a sensor after the main jam was removed.
The paper stack or media choice is causing repeated feed problems.
Service
When service or replacement is more likely
- -A W-01 by itself is usually recoverable, but repeat jam warnings deserve a feed-path check.
Avoid wrong turns
Common misreads of this message
- -Treating the message like a confirmed failed part instead of a support clue about which system has stopped the printer.
- -Assuming no physical path issue exists just because no full sheet is visible at first glance.
See also
Related codes in this family
Explore more
More Epson printer families
Read this next
Helpful guides for this problem
Guide
When a printer says paper jam but there isn't one
What a false paper-jam warning usually points to, from hidden scraps and tray issues to faults that are no longer simple jams.
Guide
How to tell if a printer fault is a cartridge issue or a service issue
How to separate ordinary cartridge or toner trouble from the kind of printer fault that usually points to real service.
Guide
How to find the right printer model family before using error codes
How to match the right printer family or series before trusting an error page that might only be a near match.
Boundary
When to stop troubleshooting and move to support
Use the message once to classify the problem, then move to support if the printer still cannot return to ready after the first safe checks.
Keep browsing
Where to go next
Source notes
Epson's ET-2980 status table routes W-01 through the paper-jam recovery path rather than the deeper fatal-error path.
Built around Epson ET-2980 and ET-2980U support guidance plus the linked product status-message table. Panel wording can vary slightly by firmware or regional variant.
Printer error codes can vary a little by firmware, region, and exact model variant. Use this guide as a family-level starting point and stop if the next step would require disassembly or service-mode changes.
Known family variants: ET-2980, ET-2980U
Last reviewed: 2026-04-12
Reference: Open reference